copyright ©2008-
Eco-
Eco-
Tel: (780) 497-
Eco-
We specialize in the removal of unsightly or contaminated material
From any surface for Fire, Flood, Vandalism or Restoration.
Soda Blasting uses No Hazardous Waste Material, Chemicals, Abrasives, Solvents or Damaging Material harmful to the Environment.
Aircrafts, Cars, Parts, Trailers, Trucks, Heavy Equipment,
We do it all...
Soda Blasting is the safest method of stripping layer by layer to the original condition of the factory metal and will not scratch, etch or warp metal, after removing all the paint, also will not scratch glass, chrome or rubber and requires no masking.
Media Blasting with the finest recycled glass is the most cost effective and fastest method of removing paint, body fillers or anything to factory metal, and blasted by our professionals will not warp or heat the metal, but is only recommended if there is no engine, glass, rubber or anything you do not want etched or have to mask off. Plus this product is also ECO Friendly.
This method also gives the metal a good profile to adhere the paint.
We are a complete Mobil Service and will come to your location of choice anywhere in Alberta or Saskatchewan.
Prices below (are subject to change without notice...)
Media Blasting based on 2 door sports car, ie: mustang, charger, camaro, etc. with no motor, no glass, in other words stripped clean will run you about $1400 to strip to bare metal...
Outside of Car $650.00
Inside of Car $350.00
Underbody Starting @ $400.00
Parts inside/outside $190.00
The proper way to restore your automobile is to strip all the paint, primer, bondo, and rust inside and outside of your automobile. If you want to media blast your automobile without following these instructions and we are required to cover, mask or prepare your automobile for blasting then there are additional charges that will apply that could run you double that cost listed above.
To prepare your car for paint, simply wash it with soap and water, and rise well. Please let the blaster know if you wish to have any filler removed if you wish to start completely fresh.
Until the car is washed you will not get any flash rusting as the soda will protect the metal until it has been removed.
To get your next project started, or request our services then please fill out our “Request Form” and we will contact you with a plan for getting all your blasting needs completed.
We will require a retainer for any blasting that is required outside of our are of operations, which is located in the Lac Ste. Ann County of Alberta, Canada.
For 2010 we now offer FREE! Pick-
We can transport up to 30’ long and a combined weight of 18000 lbs.
You may also drop off your projects at our location in Mayerthorpe, AB with prior
consent by contacting us at: 1-
GPS Location:
N 53o 57.430
W 115o 08.336
Elev: 707m
Nearest Address: 5248-